Mill the board, cut it in half and label pins and tails.
Cut a shallow rabbet on the inside of the tail board to accept the pin piece later.
Layout the tails and saw (that’s apparently a tricky part for me).
Chisel out the waste using a guide block.
Opps! I looks like I pulled out a tooth.
Lay out the pins with the tails. Use the shallow rabbet to line up the boards.
Chisel out the waste where the tails will go using a guide block again.
On the left, the first set. On the right, the second set.
Fill in your details below or click an icon to log in:
You are commenting using your WordPress.com account. ( Log Out / Change )
You are commenting using your Twitter account. ( Log Out / Change )
You are commenting using your Facebook account. ( Log Out / Change )
You are commenting using your Google+ account. ( Log Out / Change )
Connecting to %s
Notify me of new comments via email.
Notify me of new posts via email.
Enter your email address to follow this blog and receive notifications of new posts by email.
Join 647 other followers