The Final Tool Tote
Above is the final version. I’ll walk through how Jason @txheritage on Instagram.
Compass layout of corner covers. Wet molding & pressing to shape w/ arbor press.
2. The @weaverleathercraft holster leather was then soaked in water
45 degree jig & guide. Stitching sides to the ends. I used jig to prick holes. Saddle stitching corner. Mitered corners.
2. Using the same jig to hold the case, connect both sides with a bit of contact cement and stitch each side together.

Base for handle Riveting in connectors Skiving to shape Stitched up handle on the monkey
Case stitched and bottom glue up Stitching, stitching, stitching Bottom in
Skiving leather for tool holding straps Pricking tool holder Attaching the strip prior to glue up
Installing, gluing in side boards Liner , board and case sandwich Stitches to complete the liner, board, case sandwich
Installing snap into the end caps Riveting snaps for the divider Gluing on tool holding patches
Pricking attachments Some interior shots Snap in tool holders
Inside stitching with the dentist lamp Tapping on glued pieces

The end!
Such a classy looking totes! Well done!