Drilling holes in the workbench legs

Over the weekend, I finished up my tenons and got many of the holes drilled into the legs. 

The first set of holes will allow me to draw bore the short rails (stretchers) that span the width of the workbench.  The second set of holes are for the Benchcraft barrel nuts/bolts for the long rail across the front and back of the bench.  By using the bolts, I will be able to break down my bench should I ever need to move it.  The top will come off and the sides will separate from the long stretchers.

Question – My drill press was not able to completely bore the 3/4″ front holes through the legs so I used my brace to finish them up.  When I backed the brace up, the brace head would loosen and the bit would pull out.  I could only make one or two turns before the head of the brace would loosen and I’d have to re-tighten it. 

Is there something worn on the brace or was my technique in correct?  Has this ever happened to you?

 

So here’s what’s up next.  the parallel guide.  I figure that if Marc Spagnuolo can have flames on his table saw, I can have flames on my parallel guide.  Wood is Movingui.

Wine Rack Progress

I made some progress on the wine rack yesterday.  This isn’t a difficult project, I just haven’t had time to work on it.

After squaring up my shelves and making them look pretty, I used the drill press and a hole saw to rough out the holes for  the bottles.

The Paduk is really pretty wood and looks beautiful with just a planed surface.

Check out  the figured walnut in my Wenzloff saw.  Wish I could take credit for that handle.

Here’s the lay out.  Now on to dado making and shaping the holes with rasps.