Made my sticking board .. finally.

For my Six Board Chest, I really wanted to give hand cut mouldings a try.  It’ll be a simple one, so don’t get too excited.  I knew some day a project require the sticking board, but I just hadn’t gotten around to making one.  Now the only problem is to find a place to store it. Its an 8′ long board.

Its an easy project.  I picked up a 1×12′ piece of Popular from Home Depot.  I ripped off two 2″ wide pieces, glued and screwed each piece to one side and trued up the inside edge with my Veritas Jack Rabbet plane.  I also attached a bench hook strip to one end so that I can clamp it in my end vice while pushing it up against my bench dogs.  And Wa-la!!  A sticking board.

Oh, and I have on of Philip Edward’s rabbet planes on the way to cut rabbets with.  So here’s hopin’ this goes well.

 

5 thoughts on “Made my sticking board .. finally.”

  1. Well Done, she’s beautiful!! Can’t wait to see some hand cut mouldings. Did you partially sink a few screws in the end, so you can adjust them to hold your moulding blank? And is that your Philly plane already here? Or is it just a picture of the one you ordered?

    Good job!

    1. Yep! Screws are installed at the other end. The picture of the plane was sent to me by Phil. I’ll be a week or so before it arrives. In the meantime, I’ll be finishing up the feet and installing the hinges.

Leave a Reply to Marilyn Cancel reply