Today I worked on my resawn panels, cleaned them up and put the panels into the frame. AND THEN .. I installed one set of the hinges. I’ve never installed “euro hinges”, so I wasn’t sure how it would turn out. Check out the video at the end to see how I did.
I’ll post more tomorrow on how I did the hinge installation on the second door.
Panel after clean up.
Fitting panel into door frame.
Glue up.
Fitting test piece for hinges.
Fitting the door to the opening.
Sweet,
The panel looks great too.
How wide is it?
Thanks! 🙂 The panel with the 1/4″ tabs to fit in the frame is 12″. The original board was 16″. I got it from Northwest Lumber – http://www.nwtimber.com/
Sweet ! It´s nice to see such smoothness, congrats Marilyn, keep it up !