Category: workbench

Making the track for the sliding deadman

So I debated how to make the track that the bottom of the sliding deadman slides on.  I decided to use my wooden foreplane with the strongly cambered blade to take down the thickness on one side and then try my hand at rip sawing the other side.

So fun with planes first!

I kept track of my progress with the bevel gauge.

Then I cleaned up any ruff patches with my small scraper after getting it to the final surface with my Jack plane.

Then I took off the knife edge with my jack plane and jointer fence. Way more fun that scary angled table saw blades.

Rabbets, rabbets, rabbets ..

I got the chance to add my shelves into the bottom of the workbench.  The solid wood maple shelf pieces will sit on the ledger strips that I installed earlier.  Each shelf piece has a rabbet on opposite side edges so that the pieces fit into one another.

After the rabbets are all done and some notching to fit the pieces around the legs, it looked like this.  Maple is, to me anyway, surprisingly beautiful.  I’m absolutely wanting to make more with maple.

The picture doesn’t do it justice.

In the meantime, Inspector Kitten assessed the cat toy potential of the maple shaving.


Base and ledger strip installed

I got a chance this week to installed the ledger strip around the base.

I used my skewed rabbet plane to make the grooves and cleaned it up with a chisel plane.  The strip has a 1/2″ groove that’s about an 1/8″ deep.  That fits snuggly into the groove cut into the stretchers.

I’ll be making the shelf next and then on to the deadman.